11-14 Ford F250 f350 engine VIN T, 8th digit, diesel 184K OEM

2011-2014 Ford F250SD Powerstroke 6.7L V8 diesel Engine DC3Z-6007-ARM 184K OEM NO turbo NO injectors. Engine block and cylinder head is good, *Small dent, see picture # 14* Donor vehicle 2011 FORD F-250 LARIAT White VIN# 1FT7W2BT6BEC87558 Mileage: 184440 Body Type:Crew Cab Style:4WD Crew Cab 156" Lariat Drive Type: 4x4 Engine: ENTR Powerstroke 6.7L V-8 diesel direct injection, intercooled turbo, diesel, engine with 400HP Transmission: TorqShift 6-speed automatic 6 SPEED AUTO TRANS (6R140) TRCV Axle Ratio: 3.55 ***Warranty covers the Long Block (Engine Block, Cylinder Heads, Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters). There is NO core charge for this engine. To aid in installation, you get to keep your current engine and all attached accessories.*** ***What is NOT Covered or Guaranteed to be included: The engine you receive may or may NOT include some additional accessories and extra parts. If included these parts are sold AS-IS with NO WARRANTY and were included to help protect the engine during storage and shipping. Examples of these non-warranty parts include switches, sensors, cables, coils, wires, injectors, electronics, belts (including timing belt/chain), hoses, water pumps, brackets, intake/exhaust manifolds, oil pans and turbos/superchargers (if equipped). To aid in installation, you get to keep your current engine and all attached accessories. Warranty does NOT cover labor, diagnostic, towing or rental car costs.*** Installation Check List: (Failure to complete the following will void Warranty) - Determine why the original engine failure occurred and make appropriate repairs. - Insure this engine is the same application as the one being replaced. - Clear all computer diagnostic codes from the vehicle prior to installing. - Exchange the oil pan and pick up tube. - Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets). - On crankshaft bolts that are drilled through sealant must be applied to avoid leaks. - Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed) - Replace the timing belt. - Remove all cap-plugs orifice covers. - Replace water pump. - Install replacement sparkplugs & wires. - Exchange the flywheel and bolts. - Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors). - Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer. - Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze. - Drain excess oil and coolant from exhaust system. - If equipped with an engine oil cooler the radiator or external cooler must be replaced. - Insure the cooling system is flushed and functioning properly. ***Warranty does NOT cover labor, diagnostics, towing, rental car, or any other expense related to an item being defective/damaged*** OEM DC3Z-6007-E, BC3Z-6007-D, DC3Z-6007-ARM, BC3Q-6A505-CB, BC3Q-6582-CC Pre-owned Normal use wear Actual pictures