14-16 Nissan Rogue SV 2.5L Engine Motor QR25DE VIN 5 1st digit USA built *ReaD*

2014-2016 Nissan Rogue SV 2.5L Engine Motor QR25DE VIN 5 1st digit USA built 10102-4BA0A OEM *ReaD* *Broken mount, see pictures # 14-15* *Crack, see picture # 16* *Will fit ONLY Nissan Rogue, will not fit Nissan Rogue Sport it is two different vehicles* ***Warranty covers the Long Block (Engine Block, Cylinder Heads, Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters). There is NO core charge for this engine. To aid in installation, you get to keep your current engine and all attached accessories.*** ***What is NOT Covered or Guaranteed to be included: The engine you receive may or may NOT include some additional accessories and extra parts. If included these parts are sold AS-IS with NO WARRANTY and were included to help protect the engine during storage and shipping. Examples of these non-warranty parts include switches, sensors, cables, coils, wires, injectors, electronics, belts (including timing belt/chain), hoses, water pumps, brackets, intake/exhaust manifolds, oil pans and turbos/superchargers (if equipped). To aid in installation, you get to keep your current engine and all attached accessories. Warranty does NOT cover labor, diagnostic, towing or rental car costs.*** Installation Check List: (Failure to complete the following will void Warranty) - Determine why the original engine failure occurred and make appropriate repairs. - Insure this engine is the same application as the one being replaced. - Clear all computer diagnostic codes from the vehicle prior to installing. - Exchange the oil pan and pick up tube. - Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets). - On crankshaft bolts that are drilled through sealant must be applied to avoid leaks. - Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed) - Replace the timing belt. - Remove all cap-plugs orifice covers. - Replace water pump. - Install replacement sparkplugs & wires. - Exchange the flywheel and bolts. - Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors). - Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer. - Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze. - Drain excess oil and coolant from exhaust system. - If equipped with an engine oil cooler the radiator or external cooler must be replaced. - Insure the cooling system is flushed and functioning properly. ***Warranty does NOT cover labor, diagnostics, towing, rental car, or any other expense related to an item being defective/damaged*** Donor vehicle 2016 Nissan Rogue SV Gray VIN# 5N1AT2MV1GC815597 Miles 101973 Body Type: Sport Utility Vehicle Drive Type: AWD Style: AWD 4dr SV Engine: 2.5L I-4 DOHC, variable valve control, regular unleaded, engine with 170HP STDEN 2.5L DOHC 16-Valve I4 Engine Transmission: CVT Axle Ratio: 5.694 Exterior Color: KAD - Gun Metallic Interior Color: G - Charcoal Option Codes: 50S, BUM, FL2, MR2, MRF, SGD, Z66, L92, C03, J01, B92, B93, S92 OEM 10102-4BA0A, 10102-4BA5A, 101024BA0A, 101024BA5A Used Normal use wear Actual pictures