17-20 Toyota Sienna 3.5 Engine VIN Z 5th digit 2GRFKS engine w/o oil cooler 64K

2017-2020 Toyota Sienna 3.5L 296HP STDEN DOHC V6 SMPI 2GRFKS Engine w/o oil cooler 64K 19000-0P520 OEM Donor vehicle 2017 Toyota Sienna XLE Gray VIN# 5TDDZ3DC7HS170359 Miles 64164 ***Warranty covers the Long Block (Engine Block, Cylinder Heads, Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters). There is NO core charge for this engine. To aid in installation, you get to keep your current engine and all attached accessories.*** ***What is NOT Covered or Guaranteed to be included: The engine you receive may or may NOT include some additional accessories and extra parts. If included these parts are sold AS-IS with NO WARRANTY and were included to help protect the engine during storage and shipping. Examples of these non-warranty parts include switches, sensors, cables, coils, wires, injectors, electronics, belts (including timing belt/chain), hoses, water pumps, brackets, intake/exhaust manifolds, oil pans and turbos/superchargers (if equipped). To aid in installation, you get to keep your current engine and all attached accessories. Warranty does NOT cover labor, diagnostic, towing or rental car costs.*** Installation Check List: (Failure to complete the following will void Warranty) - Determine why the original engine failure occurred and make appropriate repairs. - Insure this engine is the same application as the one being replaced. - Clear all computer diagnostic codes from the vehicle prior to installing. - Exchange the oil pan and pick up tube. - Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets). - On crankshaft bolts that are drilled through sealant must be applied to avoid leaks. - Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed) - Replace the timing belt. - Remove all cap-plugs orifice covers. - Replace water pump. - Install replacement sparkplugs & wires. - Exchange the flywheel and bolts. - Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors). - Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer. - Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze. - Drain excess oil and coolant from exhaust system. - If equipped with an engine oil cooler the radiator or external cooler must be replaced. - Insure the cooling system is flushed and functioning properly. ***Warranty does NOT cover labor, diagnostics, towing, rental car, or any other expense related to an item being defective/damaged*** Body Type:Passenger Van Drive Type:AWD Style:XLE AWD 7-Passenger (Natl) Engine: 3.5L V-6 port/direct injection, DOHC, variable valve control, regular unleaded, engine with 296HP STDEN 3.5L DOHC V6 SMPI Engine Transmission: 8-speed automatic Axle Ratio: 3.003 OEM 19000-0P520, 29300-0P010-00, F2GR-L83E Used Normal use wear Actual pictures