2021-23 Ford Escape Bronco Sport 1.5L Engine vin 6 8th digit 63K miles

2021 Ford Bronco Sport EcoBoost 1.5L I-3 DOHC Ti-VCT Engine w 181HP 63K LX6G-6007-ACA OEM *Will fit ONLY Ford Bronco Sport, will not fit Ford Bronco it is two different vehicles* Donor vehicle 2021 Ford Bronco SPORT BIG BEND White VIN# 3FMCR9B62MRB00353 Miles 63,162 ***Warranty covers the Long Block (Engine Block, Cylinder Heads, Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters). There is NO core charge for this engine. To aid in installation, you get to keep your current engine and all attached accessories.*** ***What is NOT Covered or Guaranteed to be included: The engine you receive may or may NOT include some additional accessories and extra parts. If included these parts are sold AS-IS with NO WARRANTY and were included to help protect the engine during storage and shipping. Examples of these non-warranty parts include switches, sensors, cables, coils, wires, injectors, electronics, belts (including timing belt/chain), hoses, water pumps, brackets, intake/exhaust manifolds, oil pans and turbos/superchargers (if equipped). To aid in installation, you get to keep your current engine and all attached accessories. Warranty does NOT cover labor, diagnostic, towing or rental car costs.*** Installation Check List: (Failure to complete the following will void Warranty) - Determine why the original engine failure occurred and make appropriate repairs. - Insure this engine is the same application as the one being replaced. - Clear all computer diagnostic codes from the vehicle prior to installing. - Exchange the oil pan and pick up tube. - Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets). - On crankshaft bolts that are drilled through sealant must be applied to avoid leaks. - Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed) - Replace the timing belt. - Remove all cap-plugs orifice covers. - Replace water pump. - Install replacement sparkplugs & wires. - Exchange the flywheel and bolts. - Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors). - Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer. - Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze. - Drain excess oil and coolant from exhaust system. - If equipped with an engine oil cooler the radiator or external cooler must be replaced. - Insure the cooling system is flushed and functioning properly. ***Warranty does NOT cover labor, diagnostics, towing, rental car, or any other expense related to an item being defective/damaged*** Body Type:Sport Utility Drive Type:4x4 Style:Big Bend 4x4 Engine:EcoBoost 1.5L I-3 port/direct injection, DOHC, Ti-VCT variable valve control, intercooled turbo, regular unleaded, engine with 181HP, 996 1.5L EcoBoost Engine Transmission:8-speed automatic Axle Ratio:3.8 STDAX 3.80 Axle Ratio OEM LX6G-6007-ACA, LX6Z-6007-H Used Normal use wear Actual pictures